Add enough of the wire weight to bring the weight up to 4.9 oz. The remaining . 1 oz is reserved for paint and decals.Click to see full answer. Besides, can you put weights on top of pinewood derby car?The heavier your pinewood derby car, the faster it will go. Most race rules limit the weight to 5 oz so you want your car as close to the limit as possible. The Wedge block will need about 2.5 oz of additional weight to bring it up to the 5 oz limit. You should install the weights in your car before you paint it. what is the best paint to use on a Pinewood Derby car? We tested over 100 different paints and selected the ones that gave the best results on Pinewood Derby cars. These high gloss acrylic paints work best if no primer or wood sealer is used – Just sand and paint. All of our paints are water based. They are non-toxic and water wash-up. Just so, where is the best place to put weights on a Pinewood Derby car? PUT MOST OF THE WEIGHT IN THE BACK Science says the heaviest part of your car should be about 1 inch in front of the rear axle.Do you glue Pinewood Derby axles?Most wood glues will work fine for this. To glue the axles to your car, first insert the axles (with wheels) in the slots and check for alignment. When all looks good, turn the car over and apply a small amount of glue near the end of the axle. It is important that you do not get any glue near the wheels.
ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6hprBlnaqwqXnWnqCgoKRixKq4y2anmqGeqXqisMNmq6hlkWK9qrrEsKaonF2ZsrOu2Gaamqpf